Highest quality standards are achieved through the implementations of latest technology, decades of experience and everlasting moral values , which have helped us to retain our customers as well as multiply them.
Type LR25O-N
The Type LR 250-N is supplied with built-in rectifier and switch and the unit is supplied ready for connection to AC supply with approx. 3 meters long rubber cable and safety plug.
The magnet body is a dynamo steel casting of high permeability. The exciter coil is wound of copper wire and cast into the casting with impregnating and sealing compound of good heat conductivity. Two pairs of suspension plugs, one on the top ,the other at the side permit suspension of the magnet with pole face located either horizontally or vertically.
An integrally cast terminal box at the top encloses the cable terminals, rectifier set in single phase bridge connection and switch.
Type LR25O-N 2
The Type LR 250-N2 has the same dimensions and technical specifications ,but is supplied with separate control unit. The coils are however designed for use with the control unit of Type SLV only.
SEPARATE CONTROL UNIT
TYPE : SLV-4 Dl25O
The control unit is designed with a rectifier set in single phase bridge connection, switch, pilot lamp, fine wire fuse and interruptor (UT).
This control unit is suitable for one to four magnets and all magnets connected to one control unit are switched ON and OFF in common.
* To embrace new technologies and methods. * To give unsurpassed products and services to the clients. * To constantly look for improvement and changes.